SDNET Adapter

10,00

This adapter allows to connect a Enc28j60 module to the Apollo’s Vampire Accelerator and offer ethernet connection. Also has a MicroSD connector so you can use the SD card too. Also includes a 2.2k resistor required to use with the Enc28j60 module.

6 in stock

Category:

Description

This adapter allows to connect a Enc28j60 3v3 module to the Apollo’s Vampire Accelerator and offer ethernet connection. Also has a MicroSD connector so you can use the SD card too. Also includes a 3.3k resistor required to use with the Enc28j60 3v3 module. The pins are not soldered to the sdnet adapter since there are people that like to solder the cables directly to the pcb instead to the pin rows.

Connection

Just connect pins INT,SI,SO,SCK,GND to the ENC28j60 3v3 module. 3v3 from the SDNET adapter goes to the VCC pin of the ENC28j60 module.

Old version tips

Note: It seems that not all the ENC28j60 adapters has the same pinout. If you have problems to connect the SDNET adapter with the LAN adapter, please try this alternative connection.

Printed seen from above:

5V OO GND

OO
OO INT
SI     OO SO
CS    OO SCK
3,3V OO GND

Alternative

5V OO GND

OO INT
OO SO
SI     OO SCK
CS    OO
3,3V OO GND

Thanks to Alex (alf24de) for the alternative pinout.

Tiago Epifanio Also made a great wiki on this address: https://github.com/tiagoepifanio/sdnet/blob/master/tutorial_en.md

Pedro Cotter from the A-Team also has shared a good video to setup RoadShow with the adapter.

Any doubt please send me an email to [email protected]

 

Additional information

Weight 100 g
Dimensions 10 × 10 × 10 cm
I want soldered pins

By adding this option, the pins will be soldered directly to the PCB of the sdnet adapter.